General Electric PBM21 Instructivo Y Advertencias página 69

TRANSFER THE TOP HINGE TO
11
OPPOSITE SIDE.
11.1 Remove the hinge base and flip the hinge like the picture
and remount hinge base.
Top hinge (Left Side)
11.2 Insert the top pin hinge inside
the hole in the door. Make sure the
door is aligned with the cabinet
in the opposite side from the
hinge. Attach the hinge to the
top of the cabinet loosely with
the bolts.
Make sure the gasket on the
door is flush against the cabinet
and is not folded. Support the
door on the handle side and
make sure the door is straight
and gap between the doors
is even across the front. While
holding the door in place,
tighten the screws to 60 in-lbs.
INSTALL THE LEFT HINGE COVER.
12
(For models with freezer door)
12.1 Locate the left hinge cover
that comes with the kit.
12.2 Using a Phillips screwdriver
install the screws with the
hinge cover.
INSTALL THE LEFT HINGE COVER.
13
13.1 Remove the front insert from the left hinge cover.
13.2 Using a Phillips screwdriver install the screws with the
hinge cover.
13.1
Top hinge (Right Side)
13.2
INSTALL THE RIGHT HINGE COVER.
14
14.1 Insert the front insert in the right hinge cover.
14.2 Using a Phillips screwdriver install the screws with the
hinge cover.
Note: For models with freezer door, locate the front insert that
comes with the kit.
14.1
TRANSFER THE FRONT COMPONENTS
15
ON THE REFRIGERATOR DOOR.
15.1 Using a Phillips screwdriver remove the screws holding
the plastic part shown below from the left side and install
them on the opposite side.
Note: Refer the HANDLE INSTRUCTIONS for remove and attach
the handles.
INSTALL THE LOGO BADGE.
16
16.1 Locate the new logo badge from the kit, remove the
adhesive backing paper and align the pins on the back
of the badge with the holes in the door. Apply presure to
the badge to ensure it sticks to the door.
16.2 Locate the plug button from the kit and install it in the
opposite side of handle.
14.1
69
14.2
14.2