Motor Specifications and Electrical Requirements (con't.)
Wire Sizes
NOTE: Make sure the proper extension
cord is used and is in good condition. The
use of any extension cord will cause some
loss of power. To keep this to a minimum
and to prevent overheating and motor
burn-out, use the table below to deter-
mine the minimum wire size A.W.G.)
extension cord.
For circuits that are farther than 100 feet
away from electrical service box, the wire
Unpacking and Checking Contents
Tools Needed
3/4" or 19mm, 12mm
Socket
and Socket Wrench
Combination Wrench,
1/4" Hex "L" Wrench
with #2 Phillips tip
(supplied)
Unpacking
WARNING: To reduce the risk of
injury from unexpected starting
or electrical shock, do not plug
the power cord into a power
source outlet during unpacking
and assembly. This cord must
remain unplugged whenever you
are working on the saw.
This Miter Saw is shipped complete in one
box.
WARNING: Although compact,
this saw is heavy. To reduce the
risk of back injury, get help
whenever you have to lift the
saw.
1. Remove the miter saw from the carton
Draw Light
Line on Board
Along this Edge
Combination Square
Should be no Gap or Overlap when Square
is Flipped Over in Dotted Position
size must be increased proportionately in
order to deliver ample voltage to the saw
motor.
Extension Cord
Length
110-120V
0-25 Ft.
26-50 Ft.
Combination Square Must be True
by lifting the saw with the carrying han-
dle.
1. Place the saw on a secure, stationary
work surface and look the saw over
carefully.
List of Loose Parts
NOTE: Before beginning assembly, check
that all parts are included. If you are miss-
ing any part, do not assemble the saw. E-
mail us at info@ridgidwoodworking.com if
any parts are damaged or missing.
Sometimes small parts can get lost in
packaging material. Do not throw away
any packaging until saw is put together.
Check packaging for missing parts before
contacting RIDGID. A complete parts list
(Repair Parts) is at the end of the manual.
Use the list to identify the number of the
missing part.
10
Wire Sizes
Required for 120V
(A.W.G.)
14
12
Straight Edge of
Board 3/4" Thick
This Edge Must
be Perfectly
Straight