ifrogz AIRTIME Manual De Instrucciones página 2

AIRTIME Earbuds Instructions
Introduction
Welcome to Truly Wireless Audio. Now, you never need to plug your earbuds in again.
AIRTIME True Wireless earbuds free you to enjoy music without anything holding you back.
Pairing the Wireless Earbuds with Your Device
1. Simply open the case and a pairing signal will be sent to your Bluetooth® device. The left
earbud will flash white, indicating pairing mode.
2. Ensure your device's Bluetooth® connection is on and select "IFROGZ AIRTIME."
3. Complete any additional paring steps based on your device. The earbuds' lights will turn off
indicating that pairing was successful. Congrats, your wireless earbuds are now ready to use!
You can also turn on pairing mode by pressing the button in the charge case for 5 seconds.
Turning Earbuds On/Off
To turn the earbuds on, simply open the case and close the case.
If you'd like to turn an individual bud on, press and hold the button on it for 3 seconds. It will flash
white until it's connected to a device. It will turn off if not paired within 60 seconds.
To turn earbuds off, simply return them to the case. You can also press and hold the button on the
earbud for five seconds to turn it off; it will flash red indicating power is off.
The earbuds will go into hibernation mode if not used for 20 minutes.
Using the Earbuds
The circle on each bud is a button you can use to navigate music and calls. Here's how to use it.
Play/Pause = Quick press
Next Song = Double press the right earbud.
(Note: This only works when the music is playing.)
Previous Song = Double press the left earbud.
(Note: This only works when the music is playing.)
Answer Call = Quick press
End Call = Double press
Cancel Call = Press and hold for two seconds
Siri or Voice Command = Double press (Note: This only works when music is not playing and
there's no
connection nearby.)
Switch EQ = Press for 1-2 seconds, a voice will indicate a new setting. (Note: This only works when
music is playing.)
Third Party Calls:
End current call and answer new call = Quick press