Atag CM4411 Manual De Instrucciones página 117

USE
2
3
3. The display shows INSERT WATER SPOUT! Insert the hot water
spout and place a cup underneath. (fi g. 2).
4. The display shows PRESS MENU. Press the MENU button. After
a few seconds some water comes out of the hot water spout.
When the cup is fi lled with about 30 ml of water, the progress bar is
completed.
5. The display shows TURNING OFF... PLEASE WAIT...
The appliance switches off.
6. Extract the appliance by pulling it outwards with the special handles.
Open the lid and fi ll the container with coffee beans (fi g. 3). Then
close the lid and push the appliance inwards.
To prevent malfunctions, never fi ll with ground coffee, frozen or
caramelised coffee beans or anything else that could damage
the appliance.
7. Press the on/off button on the control panel. The display shows
HEATING UP... PLEASE WAIT... The appliance is heating up.
When the appliance has fi nished heating up it displays: RINSING.
The appliance performs an automatic rinse cycle (a little hot water
comes out of the coffee dispenser and is caught in the drip tray).
8. If you want to make a short coffee (less than 60 cc), to make it
hotter, fi ll the cup with this hot rinsing water fi rst. You can also use
the menu setting RINSING (see "Resetting the appliance to factory
settings" on page 28).
9. The appliance displays the basic settings (cup size and coffee
strength).
EN 9