Atag CM4411 Manual De Instrucciones página 121

USE
Never remove the water tank when the appliance is dispensing
coffee. Otherwise, the appliance will not be able to make the coffee.
If the appliance malfunctions, do not contact the service centre
straight away, but fi rst look at the instructions on pages 30 until 33.
If this does not help, contact the customer service.
Changing the quantity of coffee
The appliance is factory preset to automatically deliver the following
quantities of coffee:
• espresso cup;
• small cup;
• medium cup;
• large cup;
• mug.
To change these quantities, proceed as follows:
1. Press the MENU button and press the scrolling buttons < or > until
the menu option COFFEE PROGRAM appears. Confi rm the menu
option with the OK button.
2. Select the cup size you want to change with the scrolling buttons <
or >. When the desired cup size is displayed, confi rm it with the OK
button.
3. A bar appears on the display, which can be made bigger or smaller;
this represents the cup fi lling quantity. A different quantity can be
selected using the scrolling buttons < or > in 10 steps. A full bar
indicates that the maximum cup fi lling quantity of 220 ml is selected.
4. Select the desired cup fi lling quantity and confi rm it with the OK
button to program this setting. (If you don't press the OK button,
the appliance automatically returns to the coffee mode after 120
seconds without saving.)
After programming the display automatically jumps back to the
menu option for setting the fi lling quantity. To go back to the coffee
mode immediately, press the MENU button twice or wait about
120 seconds until the appliance automatically returns to the coffee
mode.
EN 13