Installation Instructions; What You Should Pay Attention To - Atag CM4411 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

What you should pay attention to

• After removing the packaging, make sure the product is complete
and undamaged. If in doubt, do not use the appliance and contact a
qualifi ed professional.
• Installation must be carried out by a qualifi ed techncian and in
compliance with current regulations.
• Packing elements (plastic bags, polystyrene etc.) must not be left
within reach of children as they may represent a hazard.
• Never install the appliance in environments where the temperature
may reach 0 °C or lower (the appliance may be damaged if the
water freezes).
• Make sure the mains voltage corresponds to the voltage indicated
on the appliance rating plate. Connect the appliance to an effi ciently
earthed socket with a minimum current rating of 10A only. The
manufacturer may not be considered liable for possible incidents
caused by the failure to adequately earth the mains.
• The power socket has to remain visible after installation.
• Never touch the plug with damp hands.
• Never pull the power cable as you could damage it.
• This appliance can be installed over a built-in oven it he latter is
fi tted with a cooling fan at the rear (maximum power: 3KW).
• Do not use multiple plug adapters or extension leads.
• The power cable on this appliance must not be replaced by the user
as this operation requires the use of special tools. If the cable is
damaged or requires replacing, contact an authorised service centre
only to avoid all risks.
• For the electrical connection use a HO5 VV-F type cable as
indicated in the table below:
Conductors
230 V ~+ ~
• You should personalise water hardness as soon as possible
following the instructions in 6.2.2 on page 24 and 25.
Amount x size
2
3 x 1.0 mm
EN 35