Brita PURITY 1200 Clean Manual De Instrucciones página 18

6.1 Removing the Filter Cartridge
• Switch off the power supply of the terminal equipment (remove plug).
• Close the inlet valve
• Place the fl ush hose in a bucket and remove pressure from the fi lter system by
opening the fl ush valve
Note: If the escaping water is more than 1 litre, the inlet value
closed or is blocked with scale.
• Stand on the kick loops
vessel lid
far as it will go.
• Place the pressure vessel lid
• Stand on the kick loops
vessel
• Take your feet off the kick loops
hands on the mantle handles
• Remove used fi lter cartridge
• Place the used fi lter cartridge
drainage (> 5 min).
• Lock the used fi lter cartridge
cartridge and return in the original packaging to the appropriate BRITA address listed
on the back of the cover.
6.2 Inserting the Filter Cartridge
•
•
•
•
•
•
•
•
16
at the inlet hose
6
. Collect waste water in the 10L bucket.
16
by pressing the lock
3
anti-clockwise by the mantle handles
1
and press the pressure vessel
9
.
11
from the pressure vessel
2
in the sink with the connection facing down for
2
with the transport protection cap
2
Check the O-ring seal of the new fi lter cartridge
the groove, dirt and damage. Note: The cartridge seat has been lubri-
cated with food-safe lubricant at the factory.
Check the connector seat of the fi lter cartridge O-ring
sure vessel lid for dirt and damage.
3
Place new fi lter cartridge
Stand on the kick loops
whole turning clockwise until the mantle handles
loops .
9
Stand on the kick loop
sel lid on the pressure vessel
3
marking on the lid handle
Press the pressure vessel lid
lock engages .
8
Switch on electrical power supply to the terminal device.
Execute the steps described under 5.3 to fl ush and bleed the new
fi lter cartridge .
2
.
5
with both feet while opening the pressure
9
and turning it anti-clockwise as
8
vertically on the lid handle
3
with both feet while turning the pressure
9
1
in the pressure vessel
2
with both feet; lift the pressure vessel
9
with both feet and place the pressure ves-
9
. The positioning of the arrow
1
must line up with the "INSERT" groove.
14
down and turn clockwise until the
3
is not completely
6
.
14
as far as it will go.
11
down with both
1
.
of the new fi lter
12
for correct seat in
2
in the pres-
2
.
1
are over the kick
11
1