Troubleshooting And Repair; Safety Measures; Notes On Troubleshooting; Fault And Action Table - Hupfer OTA/47-36 Manual De Instrucciones

Chapter6
Page30
6

Troubleshooting and Repair

6.1

Safety Measures

ATTENTION
6.2

Notes on Troubleshooting

Service work should only be carried out by authorised specialists. In the event of after-sales service and
when ordering spare parts specify the data given in the rating plate.
Only use original spare parts to replace defective components.
Regular inspection and maintenance of the appliance prevent disruptions to operation and ensure safety. In-
spection and maintenance intervals depend on the use of the appliance. Consult your dealer's after-sales
service department.
6.3

Fault and Action Table

Fault
Movable appliances can not keep the
track and drag to the left or right
Resistance of the swivel casters is
higher than when putting the appli-
ance into operation
Total brakes do not have any locking
action
The stacking platform does not go up
even when the load is low
Tray dispenser
OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Exposed springs
When pressing down the stacking platform manually, the springs are ex-
posed. Reaching into the gaps of the exposed springs may cause hand inju-
ries.
Never press the stacking platform down manually.
Be careful when hooking and unhooking the springs. When adjusting springs
on sharp edges, pay particular attention to the ends of the tension springs.
Possible cause
Bearings of the swivel caster(s) de-
fective
Wear of the locking brakes
Spring breakage
Troubleshooting and Repair
Safety Measures
Action
Exchange defective swivel caster(s)
Replace the locking brakes,
replace defective casters
replace the destroyed spring(s)
4330041_A2