Machine Start And Stop - Clarke Vantage 17 Manual De Operacións

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MACHINE START AND STOP

Start
1.
Prepare the machine according to the procedure shown in
the previous paragraph.
2.
If the machine has not yet been connected to the electrical
mains, connect it proceeding as follows.
Connect the power supply cable (I) to the extension (H, Fig.
8) supplied. Connect the extension plug (J) to the electrical
mains.
WARNING!
Before connecting the machine to the electrical
mains, make sure that the frequency and voltage
shown in the serial number plate/technical data
(M, Fig. 8) match the mains voltage.
3.
Lower the squeegee (A, Fig. 8) by pushing the lever (B)
downwards.
4.
Turn the solution flow control lever (C, Fig. 8) to one of the
following positions, according to the type of cleaning to be
carried out:
ECO system
: When the lever (C, Fig. 8) is in the "ECO"
position (D), the machine works in a special condition
of programmed water "economy" usage; as the water
flow is set and constant, the machine can work with a
cleaning time of 70-80 minutes [0.08 gal/min (0.3 liters/
min].
Variable system
: When the lever is turned to the left
(variable flow), it is possible to increase the capacity up
to 0.26 gal/min (1 liter/min) (E, Fig. 8).
During machine operation, it is not possible to completely
close the water flow to the brush/pad.
5.
Turn the switches (F and G, Fig. 8) to the "I" position.
6.
While keeping both hands on the handlebar (K, Fig. 8), start
the machine by pressing one or both the activation switches
(L).
Machine Stop
7.
Release the switches (L, Fig. 8).
8.
Turn the switches (F and G, Fig. 8) to the "0" position.
9.
Disconnect the power supply cable plug (J) from the electrical
mains. If necessary, roll up the power supply cable (H, Fig.
8) on the handlebar into position (N).
10.
Lift the squeegee by pushing the lever (B, Fig. 8) completely
upwards.
11.
Lift the brush/pad by activating (B, Fig. 9) the transport/
parking device (A) after inserting the relevant pin (C).
Operator's Manual - Vantage 17 Cable
ENGLISH
Figure 7
Figure 8
Figure 9
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vantage 17 cable

Tabla de contenido