Black and Decker WM125 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

90555796 WM125.qxd:??????-00 BDL500 laser
Closing and Storage
1. Loosen both locking knobs (E). (Step 11)
2. While holding the jaws as shown, tilt the Work Center towards you while lifting up on
the front jaw. The Work Center will begin to swing closed.
11
WARNING:
- PINCH HAZARD DO NOT PLACE FINGERS NEAR WORK CENTER
LEGS WHEN CLOSING.
3. Close the unit fully as shown in Step 11. Tighten both locking knobs (E). The Work
Center is now storable in a convenient minimum space.
Holding irregular shapes with Workmate
Using the swivel pegs (Q) in the appropriate holes and the independent action of both vise
handles, the Work Center can secure the most irregular shapes. It lets you grip objects
that used to be impossible to hold. Rotate swivel pegs to accept irregular shapes. Outside
swivel pegs extend capacity for the diagonal
grip with jaws fully open. (Step 12 & 13)
12
9/25/09
12:44 PM
®
Work Center
13
6
Page 6

Publicidad

Tabla de contenido
loading

Tabla de contenido