Kalorik TKG FT 1012 Manual De Instrucciones página 9

Fax +32 2 359 95 50

Each time the pilot light goes out, slide the temperature knob to a
slightly higher temperature until all the fat has melted. Once all
the fat has melted, set the temperature knob to the desired
cooking temperature. This type of fat will solidify when the
appliance cools down.
Your appliance must never be switched on through an external
❑
timer or any kind of separate remote control system.
Please note: Should the symbol
❑
surface, you need to be careful when handling the product. This
symbol means: CAUTION, this surface may get very hot during
use.
The symbol
temperature, however the other metallic or non-metallic surfaces
can also become very hot during use and it is therefore advisable
to always handle them with care and if possible with the help of
isothermal gloves or other thermal protection. In case of doubt
concerning the temperature of a certain surface it is always
preferable to protect oneself.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
BEFORE THE FIRST USE
• Remove all packaging materials.
• Check package content to verify it is complete and undamaged. Do not operate the
appliance if the content is incomplete or appears damaged.
Danger of suffocation!
Packaging materials are not toys. Always keep plastic bags, foils and foam parts away
from babies and children. Packaging material could block airways and prevent
breathing.
NOTE:
The appliance may produce an odor and/or emit smoke when switched on for the
➢
first time, as residues from the production process are eliminated. This is normal and
does not indicate a defect or hazard. Ensure ample ventilation.
Clean the appliance thoroughly before using for the first time (Cleaning and
➢
Maintenance).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you keep
the good numbering when you turn the pages of the I/B.
Don't change the page numbering. Keep the language
integrity.
is always put on the surface with the highest
9
Assembly page 9/72
be indicated on a certain
TKG FT 1012
- 180912