General Instructions - ARTERO Compac Ficha Técnica De Producto

3.
INSTRUCTION MANUAL
3.1

GENERAL INSTRUCTIONS

VERY IMPORTANT
The socket where the apparatus is to be connected should be earthed with the
corresponding circuit breaker and magneto thermal switch. Any non-compliance
with this standard releases the manufacturer from all responsibility.
When the dryer is used in a bathroom, switch it off after it has been used because the
proximity of the water may constitute a hazard, even if the dryer is switched off.
To guarantee complementary protection, the installation of a Residual current device
(RCD) mechanism which is not greater than 30mA, is advisable. Ask your installer for
advice.
Adjustable electronic dryer + blaster. High-resistance tube (3 mts), lightweight and very
flexible for maximum working comfort and extractable nozzle to increase air pressure
and speed.
Two-button resistance selection: OFF mode (heating resistance is powered off) and AUTO
mode (the power of the resistance is controlled automatically).
Dryer / Blaster: 2 high-pressure turbines, with 10- speed motor adjustment and resistance
activation control.
The OFF switch disconnects the resistance but keeps the motor running for 90" before
switching it off.
Microprocessor-controlled system for automated apparatus management.
The CPU controls the power elements (motors and heating resistance), while also taking
a reading of these elements to analyse their status for the detection of possible errors, a
keyboard for programming the required values, start-up and shutdown of the unit and
an alphanumeric display for viewing the status of the apparatus and the programmed
parameters.
There is a mains switch on the left for powering current on and off. It cuts off the current
into the drier directly. It should only be used in the event of an anomaly in the dryer or
when it is not being used over very long periods (night, holidays, weekends, etc...).
The apparatus has been designed to be hung vertically on the wall (eyehooks and Rawl-
plugs for the latter are provided), and it should be placed at a height of 1.5 m above the
floor, although if hung at a different height it would not affect the way the apparatus
works.
20 20
COMPAC ARTERO TECHNICS COMPAC ARTERO TECHNICS
DRYER BLASTER FOR ANIMALS SECADOR - EXPULSADOR - PARA ANIMALES
PRODUCT SPECIFICATIONS
FICHA TÉCNICA DE PRODUCTO