Assembly; Tools Required - EarthQuake Dually 10310 Manual Del Operador

WARNING
DO NOT REFUEL WHILE SMOKING, NEAR OPEN FLAME,
OR OTHER POTENTIAL HAZARDS.
FUEL IS HIGHLY FLAMMABLE AND MUST BE HANDLED
WITH CARE. NEVER FILL THE TANK WHEN THE ENGINE
IS HOT OR RUNNING. ALWAYS MOVE OUTDOORS TO
FILL THE TANK.

ASSEMBLY

UNPACKING
Carefully lift the powerhead out of the box, remove any packing
material and cut any ties.

TOOLS REQUIRED

Two (2) 9/16" Wrenches
ASSEMBLY INSTRUCTIONS
1. Insert the output shaft of the transmission (A) in the open
end of the Flex Coil ShockTop (B).
2. Line up the bolt holes through the Flex Coil ShockTop and
the output shaft of the transmission.
3. Place the included 3/8-16 x 1.5 inch bolt (C) through the bolt
hole.
4. Hand-thread the 3/8-16 "Bi-way" lock nut (D) on the bolt.
5. Using two 9/16 inch wrenches, securely tighten the nut and bolt.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
Dually™ Earth Auger Powerhead
C
Figure 1
Operator's Manual
A
D
B
9