Auta 702205 Manual De Instrucciones página 5

Functioning
calling and conversation
When a call is received from the entrance panel, the phone starts ringing for a maximum of 30 seconds. As standard,
it performs 4 rings with intervals of 4 seconds between each of them.
During the call period, the user can open directly by pressing the button
conversation. The conversation has a maximum of 90 seconds. If you want to continue with the conversation, press the
button
AUX 1/ON
INTERCOM calling
Pick up the handset of the phone, press the code of the device to which you want to make a call then press OK. Press
C to rectify. With each press the green LED on the keyboard will flash.
If the phone you want to call is not available, the keyboard will emit several red flashes and will return to standby.
broadcast calling function
With the phone in standby press the button
handset it will make a calling to all devices installed at system.
self-starting
By pressing the button
is present in the installation the system will do the self-starting to the last one from which it receives a call.
Once the communication is established, an opening can be made by pressing the button
calling to concierge
If the phone is in standby, handset is picked up and the button
unit. If the system does not have a concierge unit installed, the phone will emit an error beep.
adjust of the calling volume
To adjust the volume of the call, insert a clip or similar through the indicated hole and press with it lightly.
The phone has two volume levels (MEDIUM and HIGH)
melody selection
To select a ring tone, you have to pick up the handset and press the hang switch with your finger. With it pressed, a clip
or similar must be inserted in the indicated hole and press with it lightly.
Each press selects a different melody from 8 ones available.
ding dong function
The phone allows to replace the interior bell of the house, this integrates the two calls (outside panel and house bell)
in a single device. These calls will be differentiated with different melodies and flashes automatically. In order to have
this function, you only have to connect the button of the house bell to the phone.
external functions
The monitor has 1 independent push-button that allow auxiliary functions, such as garage doors, lights, irrigation,
etc ...
To do this, an Auta auxiliary relay must be connected to the control circuit we want to control.
Priority mode
By activating this mode the phone is able to end any conversation that is currently taking place in the system. Leaving
free the communication line.
the user can establish communication with the PANEL. In the case of more than one panel
AUX 1/ON
during 3 seconds, the LED starts blinking fast. When you pick up the
is pressed, a call will be made to the concierge
, or pick up the handset to establish a
Bringing people together
EN