Arbortech Mini Carver Manual Del Usuario página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING: ALWAYS WEAR
CORRECT SAFETY CLOTHING,
INCLUDING EAR, EYE AND LUNG
PROTECTION.
DO NOT use under the wet conditions or in presence
of flammable liquids and gasses.
CAUTION: Use correct personal protection equipment
when working on materials treated or containing
toxic substances and follow local government safety
regulations.
OPERATION
Always use two hands to operate the Mini Carver/Mini
Grinder Trade placing the left hand on the auxiliary
handle and the right on the tool body ( Fig. J)
Ensure the machine is running BEFORE contacting
the material, to be worked on. To sand, grind or
woodcarving, hold the Mini Carver/Mini Grinder Trade
as shown in Fig. K
CUTTING GRIP
Use the Mini Industrial Blade to cut or remove wood
and plastics.
Use the Mini Sanding Pads for cleaning and sanding
wood, plastics, metal, paint and much more.
Use the diamond blade for cutting and recessing any
masonry based material.
Use the grinding disc to grind metal.
STARTING OPERATION
Observe correct mains voltage! The voltage of the
power source must agree with the voltage specified
on the nameplate of the machine. Power tools marked
with 230-240V can also be operated with 220 V.
SHOWING ANGLE & DIRECTION OF
CUT
25-30° is a comfortable working angle.
Use the bottom edge of the blade (as shown in Fig.L /
M) and not as in Fig.N.
SWITCHING ON AND OFF
To start the power tool, push the On/Off switch 3
forwards.
To lock the On/Off switch 3, press the On/Off switch 3
down at the front until it latches.
To switch off the power tool, release the On/Off switch
3, or if it is locked, briefly push down the back of the
On/Off switch 3 and then release it.
-
Check grinding tools before using. The grinding
tool must be mounted properly and be able to
move freely.
Test run the grinder with no load prior use. Do not use
damaged, out-of-centre or vibrating tools.
CAUTION:
Restarting protection – The restarting protection
feature prevents uncontrolled restarting of the
machine after an interruption in the power supply.
To restart the operation, switch the On/Off switch 3
to the off position and start the machine again.
WARNING:
-
Always read the safety instructions and
applicable regulations
-
Support and secure the work piece to prevent
movement and loss of control.
-
Do not exert pressure or strain the machine so
heavily that it comes to a standstill.
-
After heavily straining the power tool, continue
to run it at no-load for several minutes to cool
down the accessory.
-
Do not touch grinding and cutting discs before
they have cooled down. The discs can become
very hot while working.
TOOL
POWER SETTINGS
1
Mini Industrial Blade
Diamond Disc
2
Grinding Disc
2
Sanding Pad
1
Included with Mini Carver
2
Included with Mini Grinder Trade
MAINTENANCE
WARNING: BEFORE ANY
ADJUSTMENT, CLEANING OR
WORK ON THE MACHINE ITSELF,
DISCONNECT FROM THE POWER
SUPPLY.
APPLICATION
5-6
Wood carving
5-6
Grinding masonry material
5-6
Grinding metal
Sanding wood, metal and other
materials. Use lower speed for
1-3
higher grit sandpaper
English
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mini grinder trade

Tabla de contenido