Clik - Rear Seat Height Adjustment - Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
O. Clik - Rear Seat Height Adjustment
1. Remove your wheels by depressing the buttons on the quick release axle.
2. Use a 3mm Allen wrench and an 8mm open end wrench to remove the two bolts (Fig. 20:A)
holding the upper and lower mounting brackets together.
3. Reposition the mounting brackets to the desired height and replace the two M5 bolts.
4. Repeat on both sides of the wheelchair.
NOTE: Height adjustments are in ¼" increments.
NOTE: A front caster adjustment should be made to correspond with any change in seat angle.
Fig. 20
A
WARNING: Lowering the seat height at the rear of the seat may decrease rearward stability of
the chair. The more you move your rear wheels forward, the more likely your chair will tip over
backwards.
Always make adjustments in small increments and check the stability of your chair with a spotter
to prevent a tip-over. We recommend that you use anti-tip tubes.
DANGER: Failure to heed these warnings may cause serious injury or death.
31