How To Adjust The Basic Parameters Of The Movement - Kinetec CPM concept Manual De Empleo

Use of the hand control

How to adjust the basic parameters of the movement?

Beginning
To stop the unit
To display the upper or lower limit of the movement
To change the limit if necessary
To validate the new value, press another key
or wait more than 3 seconds.
Or
Or to display pause in extension or flexion limit
To change the pause if necessary
To validate the new value press another key
or wait more than 3 seconds. The display shows the
selected mode
Comments:
• The values shown in the 'Display' column are examples.
GB
8
Keys to press
ELBOW MODULE
80 STOP
Or
ELBOW MODULE
80 Ext
ELBOW MODULE
40 FleX
ELBOW MODULE
Or
40 Flex
ELBOW MODULE
SPEED 2
LOAD _ _ _ _ _ _
No timer
ELBOW MODULE
PAUSE HIGH
Pause low
ELBOW MODULE
Or
PAUSE low
ELBOW MODULE
40 STOP
Display
Check if the hand control is not locked
85 100
(See page 6).
85 100
The value blinks.
85 100
The new value blinks.
85 60
While the value blinks press
the
to change if necessary.
Successive presses on this key selects the
0
pause at the extension or flexion limit.
0
The new pause value blinks.
15
The unit is ready to start with the new
parameters.
0 60
Remarks
or key