MG TF 2008 Manual De Servicio página 472

ELECTRICAL
PDC SENSOR - SET
$% 86.54.15
Remove
1. Remove rear bumper valance. 1. Remove rear bumper valance.
+
REAR BUMPER VALANCE, page 76-2-11.
2. Release multiplug connector block from 'U' clip. 2. Release multiplug connector block from 'U' clip.
SP860268
3. Remove 'U' clips. 3. Remove 'U' clips.
4. Disconnect multiplugs. 4. Disconnect multiplugs.
SP860275
5. Remove PDC sensors. 5. Remove PDC sensors.
Refit
1. Fit PDC sensors and secure with 'U' clips. 1. Fit PDC sensors and secure with 'U' clips.
2. Connect multiplugs. 2. Connect multiplugs.
3. Secure connector blocks to clips. 3. Secure connector blocks to clips.
4. Fit rear bumper valance. 4. Fit rear bumper valance.
+
REAR BUMPER VALANCE, page 76-2-11.
86-20
REPAIRS
LINK HARNESS - PDC SENSOR - REAR
$% 86.54.16
Remove
1. Remove rear bumper valance. 1. Remove rear bumper valance.
+
REAR BUMPER VALANCE, page 76-2-11.
2. Position RH side boot carpet aside and disconnect 2. Position RH side boot carpet aside and disconnect
multiplug from PDC module.
3. Release clip securing link harness to body. 3. Release clip securing link harness to body.
SP860270
4. Release link harness body grommet. 4. Release link harness body grommet.
SP860272
5. Disconnect link harness lead multiplug from PDC 5. Disconnect link harness lead multiplug from PDC
harness.
6. Remove link harness. 6. Remove link harness.
Refit
1. Position link harness to body. 1. Position link harness to body.
2. Secure harness clip and grommet to body. 2. Secure harness clip and grommet to body.
3. Connect multiplugs 3. Connect multiplugs
4. Align carpet. 4. Align carpet.
5. Fit rear bumper valance. 5. Fit rear bumper valance.
+
REAR BUMPER VALANCE, page 76-2-11.