Description Of The Product; Lighting The Stove For The First Time - Palazzetti Sunny Fire Ecomonoblocco Serie Generalidades - Advertencias - Instalación - Mantenimiento

7 COMMISSIONING
AND USING THE
ECOMONOBLOCCO
7.1

DESCRIPTION OF THE PRODUCT

Before proceeding, check for any "speci c features of
the model" described for the Ecomonoblocco model in
question in the enclosed "Product booklet".
7.2

LIGHTING THE STOVE FOR THE FIRST TIME

• Check whether all the documents and accessories
for the replace insert were removed from the re
chamber.
• The enclosed heat protection glove is exclusively
designed to activate the operating handle and the
"cold hand". The glove is not re resistant!
• Thoroughly familiarize yourself with fuels and other
relevant topics discussed in your Instruction Manual.
• The rst operation of the apparatus should be in
coordination with the installer or, better still, together
with the installer. To prevent cracks or damage, all the
cladding must be dry.
• It is forbidden to turn on the appliance in the absence of
a suitable air exhaust system for external combustion.
ATTENTION! The danger of pressure reduction
also exists in the case of controlled ventilation and
extraction of air, WC extraction and extractor hoods.
• For optimal lighting, follow Section "Lighting and
heating".
• When burning for the first time after installation,
increase the temperature slowly and then burn 100 %
to reach the highest temperature.
• This first burning will cause unpleasant odours.
This is where the corrosion coating of the replace
insert burns into the surface of the steel. Although
the smell is unpleasant, it poses no health risk. You
should therefore ensure that the installation room is
adequately ventilated.
• ATTENTION! The surfaces of the panes and the
cladding get very hot during operation: Risk of burning!