Turning Off Programmes/System Deactivation; Warning Signals - Jacuzzi sasha Manual De Instalacion Y Uso

NOTE:
- to synchronise the lights, the modules must have been electrically
connected during installation, as indicated in the respective manual.
- to deactivate synchronisation and to change/turn off the lights,
you must only use the display from which this function was acti-
vated (the key is lit up green; on all other displays, the key is lit up
yellow).
- it is possible to act upon the lights even where the control system
had not been activated.
- deactivating synchronisation and changing or turning off the lights
does not influence upon Sasha keypad lock (see also "Functions
associated with keypad lock", present in the relative Sasha usage
manual).
- for Sasha mi models, the chromatic sequence (or fixed colour light)
is the same in both the sauna and hamman modules once selected.

Turning off programmes/system deactivation

■ To stop the programme under way, click on the "STOP" key:
the key relative to the programme under way, turns off, as does
the "Remote" key, indicating that the control system has been
deactivated.
NOTE: in all cases, whether by clicking on the "STOP" key or
where the programme stops normally, the control system is
automatically disabled.
■ To re-activate the control system, follow the procedure de-
scribed in Chapter "Control system activation".

WARNING SIGNALS

The symbols below, when lit up, indicate the presence of malfunc-
tions or warning conditions.
Possible causes
■ The symbol lights up after having selected the bio sauna or Ro-
man sauna programme, as a reminder to check that there is suf-
ficient water in the steamer (see also Chapter "Programming").
■ If the symbol lights up whilst a programme is under way, it
signifies that there is an insufficient water level in the steamer.
-Fill up the steamer, leaving approximately 10 cm from its opening;
if an automatic water filling device is installed, check that the tap
on the supply pipe is open and/or the water system is functioning
correctly.
Before filling the steamer tank, if this was in use, wait
at least 5 minutes so that the inner heating element
can cool down.
Possible causes
■ The symbol lights up when the respective button on the key-
pad is pressed; all functions under way are interrupted (except
the sound system if installed).
- To deactivate the alarm, press the button on the keypad once again.
Possible causes
■ The thermal fuse may have tripped.
- Wait a few minutes and see whether the signal disappears; if this
fails to happen, switch off the main switch and switch it on once
again, and then re-start the programme.
If the problem persists, contact an authorized Jacuzzi® service centre.
Possible causes
■ The light control system may be faulty.
- Contact an authorized Jacuzzi® service centre.
Possible causes
■ The management software fails to interface.
- Try turning off and then turning on the main switch and then try to
re-start the programme: if the problem persists, contact a Jacuzzi®
Service Centre.
(red light) Possible causes
■ The temperature probe may be faulty.
- Try turning off and then turning on the main switch and then try to
re-start the programme: if the problem persists, contact a Jacuzzi®
Service Centre.
32