Greenlee Communications GVIS300C Guia Del Usuario página 8

Hardware Overview
Charging
*NOTE
Only the approved charger from Greenlee
Communications may be used to charge the
GVIS300C. Use of any third-party wall charger will
void the warranty on the GVIS300C. Use of non-
approved chargers may cause personal or property
damage.
Contact Greenlee Communications to obtain
approved replacement charger packs.
9. Protective Carry Case
The GVIS300C monitor is housed in a zip-closure
carry case. The case folds closed for protection
of the screen during transport and folds open
to provide an angled view of the screen when
placed on a flat surface, such as a desk.
The unit can be hung around the neck for field
use when the included strap is connected to the
D-rings on the side of the case.
10. Inspection Scope
All models of the GVIS300C come with a high-
definition inspection scope. This scope provides
a wide viewing area on the fiber end-face to
ensure accurate automated analysis within the
GVIS300C software.
8
www.GreenleeCommunications.com
(cont'd)
Fully Charged
11. Focus Ring
When inspecting bare fiber ferrules and
patchcords, the Focus Ring on the inspection
scope should be used to endure optimal focus.
If inspecting fiber inside a non-moveable
bulkhead, the probe body can be turned to focus
the image. This is Greenlee Communications'
proprietary External Focus Mechanism.
12. Interchangeable Inspection Tip
Each inspection tip can be attached and
removed using the threaded attachment ring on
the inspection scope. Greenlee Communications
offers inspection tips for many common and
uncommon connector styles across several
industries. See the Accessories section of this
guide for more information.
13. Analysis Button
Each inspection scope included with the
GVIS300C has a button on the side of the probe
body. This button will initiate analysis when a
live fiber image is shown on the Main Inspection
screen of the GVIS300C application. The button
will also return the user to a live image after the
analysis has been run.