Snapper ST48 Manual Del Propietário página 13

ASSEMBLY
INSTALL THE UPPER SHAFT TO THE LOWER SHAFT
(See Figures 4.1 and 4.2)
W A R N I N G
Never install, remove, or adjust any attachment while string trimmer is running.
Failure to stop the motor can cause serious personal injury.
The attachment connects to the power head by means of a coupler device.
1. 6HW WKH XQLW RQ D ÀDW OHYHO VXUIDFH
2. Loosen the knob (1) on the coupler (5).
3. Push in the release button (2) located on the lower shaft (3). Align the
release button with the positioning hole (4) and slide the two shafts
together. Rotate the lower shaft until the button locks into the positioning
hole.
4
2
3
NOTE: If the button does not release completely in the positioning hole, the
shafts are not locked into place. Slightly rotate from side to side until the
button is locked into place.
4. Tighten the knob securely.
5
1
Tighten
13
2
Loosen
Fig. 4.1
Fig. 4.2