Troubleshooting - Snapper ST48 Manual Del Propietário

TROUBLESHOOTING

Problem Cause
1. The battery pack
is not attached to the
trimmer.
2. No electrical contact
String
between the trimmer and
trimmer
battery.
fails to start
when trigger
3. The battery pack is
lock button is
depleted.
depressed.
4. The lock-out
button and trigger
are not depressed
simultaneously.
1. The guard is not
mounted on the trimmer ,
resulting in an overly
long trimmer line and
motor overload.
2. Heavy cutting line is
used .
3. The motor shaft or
trimmer head is bound
with grass.
4. The motor is
String overloaded.
trimmer stops
while cutting.
5. The battery pack or
string trimmer is too hot.
6. The battery pack is
disconnected from the
tool .
7. The battery pack is
depleted.
Solution
1. Attach the battery pack to the
trimmer.
2. Remove battery check contact
and reinstall the battery pack.
3. Charge the battery pack.
4. Press down the lock-out button
and hold it , then depress the trigger
to turn on the string trimmer.
1. Remove the battery pack and
mount the guard on the trimmer.
2. Use only with nylon cutting line
0.080" diameter or less.
3. Stop the trimmer , remove the
battery , and remove the grass from
the motor shaft and trimmer head.
4. Remove the trimmer head from
the grass.the motor will recover to
work as soon as the load is removed.
When cutting , move the trimmer
head in and out of the grass to be cut
and remove no more than 8 inches
of length in a single cut.
5. Allow the battery pack or trimmer
to cool until the temperature drops to
the normal temperature.
6. Re-install the battery pack.
7. Charge the battery pack.
26