American Sanders EZ-8 Manual Del Usuario página 10

EN
This sanding machine is designed to be operated with a remote vacuum dust
collection system or with the included dust bag.
Preparing Remote Vacuum Dust Collection Systems
To prepare the machine for remote vacuum dust collection systems that have a
2˝ (5 cm) hose end, follow this procedure:
1. Install 2˝ (5 cm) hose end (figure 9, A) directly over the exhaust tube
(figure 9, B).
2. The exhaust tube can be rotated for optimum convenience.
To prepare the machine for remote vacuum dust collection systems that have a
1 ½˝ (3.8 cm) hose end, follow this procedure:
1. Install the 2˝ (5 cm) x 1½˝ (3.8 cm) hose end adapter (Part No. 30563A)
(figure 9, C) over the exhaust tube (figure 9, B).
2. Insert 1 ½˝ (3.8 cm) hose end (figure 9, D) into the adapter (figure 9, C).
NOTE: Start the remote vacuum collection system before operation.
Preparing to use the included dust bag
To prepare the machine for use with the included dust bag (Part No. 53544B),
follow this procedure:
1. Install the dust bag by pressing the end onto the exhaust tube
until the ring locks into the groove (figure 10). This is best done
by pressing on the back of the bag opening with the palm of your hand.
2. The exhaust tube can be rotated for optimum convenience.
3. To remove the dust bag from the exhaust tube, pry up the end
of the bag opening to partially release the internal rib from the
groove, then pull.
4. To empty the dust bag, unzip the disposal flap and force contents
out by inverting the bag.
NOTE: For best results, empty frequently. Follow all warnings posted in this
manual and on the dust bag.
Machine Setup
10
2˝ (5 cm)
A
Hose from
D
vacuum
system (not
included)
B
(30563A)
Exhaust Tube
C
2˝ (5 cm) Tube x 1.5˝ (3.8 cm)
hose adapter
Figure 9
Install the dust bag by
pressing the end onto the
exhaust tube until the ring
locks into the groove.
Figure 10
1.5˝ (3.8 cm)
Hose from vacuum
system (not included)