Adjustment Procedures; Maintenance - American Sanders EZ-8 Manual Del Usuario

EN
Leveling
To adjust the machine leveling follow this procedure:
1. Locate the leveling screw. See figure 12.
2. Tighten the screw (compress the leveling spring) to sand heavier on drive
belt side of sanding drum.
3. Loosen the leveling screw (relax the leveling spring) to sand heavier on the side
opposite the drive belts.
Condition - Pad creates ridges on both edges or a "hop" is experienced: Rotate
both adjusting screws equal amounts clockwise. Tighten locknuts and test on a
piece of plywood. Repeat procedure until condition is corrected. We recommend you
not exceed 1/8 rotation for each attempt.
Condition - Pad creates a ridge on the tip of the pad: Rotate both adjusting screws
counter clockwise, tighten locknuts and test. Repeat procedure until condition is
corrected. Use only 1/8 rotation for each attempt.
Condition - Pad creates a ridge on only one side of the pad: Either rotate the
adjusting screw of the side effected clockwise or rotate the adjusting screw opposite
counterclockwise, depending on whether the ridge terminates beyond the tip of the
pad or prior to it. If it is prior to the tip, adjust the side effected, otherwise adjust the
opposite side.
Dust Shoe
To adjust the dust shoe follow this procedure:
1. Disconnect machine from power supply.
2. Loosen the four screws fastening the dust shoe to the chassis.
3. Adjust the dust shoe towards the drum to improve recovery of fine particles.
4. Adjust the dust shoe away from the drum to improve recovery of coarse particles.
5. Align the dust shoe with the drum and tighten screws. See figure 12b.
CAUTION:
Failure to perform maintenance at recommended intervals may void warranty.
Sanding Chamber
Periodically blow out the sanding chamber to prevent large accumulations of debris which could interfere with the performance of the dust
recovery system.
Wheels
Periodically remove the debris from the truck and caster wheels. Debris can cause waves on a sanded surface.
Dust Bag
Remove the dust bag from the machine and shake it thoroughly to remove the sanding dust from the dust bag. Turn the dust bag inside out and
machine wash in cold water to prevent pore blockage and loss of dust recovery.
Drive Belt
Periodically check the drive belts for broken cogs or frayed edges. Frayed edges may indicate poor tracking. Realign affected belt.
Bearings
Periodically check the bearings for wear or damage according to the following schedule.
Arbor shaft: Re-lubricate every 150 hrs. w/.10 oz. of a NLGI grade 2, -30
lubricant.
Motor shaft: After 1 5000 hrs.
st
Fan shaft : After first 1500 hrs.
CAUTION:
Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs performed
by unauthorized personnel will void your warranty. Failure to perform maintenance at recommended intervals may void warranty.

Adjustment Procedures

Routine Maintenance
F (-34.4C) to 250
0
12
Figure 12
Figure 12b
F (121.1C), 58-75 SUS at 210
0
F (98.8C), grease
0