Electrical Connection Instructions - American Sanders EZ-8 Manual Del Usuario

EN
Instructions for connection to the power supply and the electrical ground.
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce
the risk of electrical shock. This product is equipped with a cord having an equipment-grounding conductor and grounding plug. The plug must be
inserted into an appropriate oulet that is properly installed and grounded in accordance with all local codes and ordinances.
WARNING:
Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with qualified electrician
or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the
product – if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a grounding attachment plug that looks like the plug illustrated in figure 12. Make sure
that the product is connected to an outlet having the same configuration as the plug. No adapter should be used with this product. Always connect
the machine to a dedicated 20 amp electrical line to prevent nuisance breaker tripping and line overload due to other devices.
WARNING:
To prevent possible electric shock, protect the machine from rain. Keep the machine in a dry building.
WARNING:
To prevent possible electric shock, always use a 3-wire electrical system connected to the electrical ground. For maximum
protection against electrical shock, use a circuit that is protected by a ground fault circuit interupter. Consult your electrical
contractor.
WARNING:
Do not cut, remove or break the ground pin. If the outlet does not fit the plug, consult your electrical contractor.
WARNING:
Have worn, cut or damaged cords replaced by an authorized service person.
Grounded
Outlet
Grounding
Pin
(United States, Mexico and Canada)
Figure 12
CAUTION:
This machine will operate only on the AC frequency and electrical voltage shown on the nameplate. Make sure you have the
correct frequency and voltage before connecting the power cord to an outlet.
This machine must be connected to the electrical ground to protect the operator from electric shock. The machine has a power cord with two
main conductors and one earthing conductor. Connect the plug to the type of receptacle shown in figure 5. The green and yellow conductor cord
is the ground wire. Never connect this wire to any terminal other than the ground terminal.
Figure 5
Electrical Connection Instructions (120V)
Grounded
Outlet
Box
Electrical Connection Instructions (230V)
WARNING:
Always use this machine with an AC three-
conductor electrical system connected to the
electrical ground. Replace any worn, cut, or
damaged cords. Replace any damaged plugs,
receptacles, or connector bodies. Do not move
the machine over an electrical cord. Always lift
the cord over the machine.
7