Electrical Connections - Balluff BSP B Serie Manual De Instrucciones

Standard and High-End Pressure Sensors
BSP-B... /-V... /-M... /-W... /-K...
Installation (continued)
Adapter for process connection
BSP pressure sensors can be adapted to different process
connections using adapters (accessories) available as an
optional extra. The adapters must be ordered separately.
Adapters for other process connections are available on
request.
Adapter G 1/4"
Ordering code: BAM01KP
Stainless steel
Connection:
Sensor end: G 1/4"
Process end: G 1/4"
Torque approx. 5 Nm
Adapter NPT 1/4"
Ordering code: BAM01KT
Stainless steel
Connection:
Sensor end: G 1/4"
Process end: NPT 1/4"
Torque approx. 30 Nm
Adapter G 1/4"
for attachment to pressure
gauge
Ordering code: BAM01KR
Stainless steel
Connection:
Sensor end: G 1/4"
Process end: G 1/4" for
attachment to pressure gauge
according to EN 837
Torque approx. 20 Nm
www.balluff.com

Electrical connections

Attention!
Always depressurize and disconnect pressure
sensors from the power supply before esta-
blishing an electrical connection.
Establish the electrical connection to the device according
to the specifications indicated on the type plate, the pin
assignment table below and the wiring diagram.
Electrical Sensors with
connections switching output
Supply + 1
Supply – 3
Signal +
Switching output 1 4
Switching output 2 2
Shield Connector
housing
Connector housing
Fig. 3: Sensor diagram with 2 switching outputs
Connector housing
Fig. 4: Sensor diagram with analog output
Sensors with
analog output
1
3
2
4
Connector
housing
English 3