Descargar Imprimir esta página

Jacuzzi play SPHERE 90 Manual De Instalación página 9

Ocultar thumbs Ver también para play SPHERE 90:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

The
shower boxes can be installed with or without wall-mount-
ed glass panes and wood footboard. Also, they come with (mod.
or without (mod.
) Turkish bath, seat and top (refer to the assem-
bly drawings).
I The shower enclosure must be installed in a corner on finished
and tiled (or water-proof ) walls, but without skirting and/or pro-
jecting parts. Assembling and installing the shower enclosure must
be carried out (in strict compliance with the manufacturer's in-
structions) by two people. Given the considerable weight of the
components to be handled, it is advisable to wear protective gloves.
I To assemble the various components in the correct way, the
walls of the installation corner must be straight. Wall compensators
let you recover crookedness by up to 10 mm.
10mm
90°
Before proceeding with installation, check that all the relevant pre-
installation operations have been carried out; see the technical
card for this.
If the water supply system is equipped with an instant water
heater, check that this is powerful enough. For gas models,
we recommend that you use models with variable power in
relation to the volume of water drawn off. Do not use hot
water accumulators without pressure.
In areas of very hard water it is necessary to install a scale-re-
mover in the water system, to prevent and/or reduce the for-
mation of scale.
Remove the shower tray from its packaging.
i
I (
drain pipe, and carefully apply silicone to the connections (
I (only for models TT;
to the drainage column connector, pass it through the hole shown.
i
I (
)
sistance mortar (or a similar material) between the bottom of the
tray and the floor to create a good support base and to keep the tray
from bending under a person's weight. Then set the shower tray on
the floor (
i
I (
test for water tightness.
i
I (
adjust it at the edge (
i
I (
able a substance.
i
I (
walls, as shown. If the gap that is created between the shower tray
and the walls is considerable, the Service Centres can supply suitable
profiles to cover the silicone.
Before proceeding with the following assembly phases, it is advisable
to protect the shower tray from any knocks and/or abrasion.
90°
i
I (
tred on the base of the shower tray, mark the position on the wall.
i
I (
10mm
mark the points for fastening (
i
I (
then insert the dowels (
i
I (
of the compensator, along the entire length.
I (only for models TT;
the shower tray, making the electric cables come out of the slot
(for the power supply and any others for the alarm circuit and
equipotential connection).
Make sure that all the cables come out of the slot, so that they will
not be squashed by the compensator.
) Connect the drainage column to the prepared
i
) After fastening the small pipe
) During installation, it is advisable to place high-re-
).
) Fasten the ring nut to the drainage column and
) Check that the shower tray is flat, if necessary
).
) Fasten the shower tray to the floor using suit-
) Apply silicone between the shower tray and the
) Making sure that the compensator is perfectly cen-
) After checking that the compensator is straight,
).
) Remove the compensator and drill the holes,
).
) Apply silicone to the two grooves on the back
i
) Replace the compensator on
).

Publicidad

loading

Este manual también es adecuado para:

Play sphere 100Play sphere 120