Elu After-Sales Service - Elu MHB158 Manual De Instrucciones

Mounting and removing the stationary stand
(fig. A & F)
With a stationary stand (option), the machine can be
used in a stationary position both upside down and
horizontally.
• If required, mount the sanding frame (14)
as described above.
• Place the belt sander on the stationary stand (18).
Guide the cord away at the side of the clamping
lever (12).
• Place the fixing bolt (19) and tighten the round
nut (20) (see inset in figure F).
• To remove the stationary stand, proceed in
reverse order.
Dust extraction (fig. A)
Since woodworking with a sander
produces dust, always install a dustbag
designed in compliance with the
applicable directives regarding dust
emission.
Do not use a dustbag or vacuum
extractor without proper spark protection
when sanding metal.
Do not sand magnesium!
• Place the dustbag (7) or dust adapter (21)
(option) over the flange (22).
• For efficient dust extraction empty the dustbag
when it is about one third full.
• Remove the dustbag from the flange, open the
zipper and gently shake out the dustbag.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded are
well secured.
• Apply only a gentle pressure to the
workpiece.
16
Switching on and off (fig. A)
• Switching on: press the on/off-switch (1).
• For continuous operation, also press the lock-on
button (3).
• Switching off: press the on/off-switch again.
Always switch off the tool when work is
finished and before unplugging.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your Elu Power Tool has been designed to operate
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an Elu authorized repair agent
where it will be disposed of in an environmentally
safe way.

Elu After-Sales service

All Elu Power Tools are thoroughly tested before
leaving the factory. However, if the Power Tool
needs repair, please contact your dealer or the Elu
Head Office for the address of the nearest Elu
authorized repair agent (please refer to the back of
this manual). Alternatively, a list of authorized Elu
repair agents and full details on our after-sales
service are available on the Internet at
www.2helpU.com.
E N G L I S H
en - 5