Preparing The Installation Cavity - Thermador T18 Serie Instrucciones De Instalación

6. Preparing the installation cavity
Assure that there are no electrical wires or plumbing in
the area which the screws could penetrate.
Risk of injury and damage!
- 2 anti-tip-angless are required for each appliance or
appliance combination (Side-by-Side).
- The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
- If the supplied fastening screws do not permit
secure attachment of the anti-tip brackets and
therefore the appliance, another method must be
used to attach the anti-tip brackets securely.
))))))))))))))))))))))))))))))))))))))))
The anti-tip-angles must have a minimum length of 41/s ''
(105 mm) over the appliance to ensure a secure stand of the
appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening a spacer
behind the anti-tip angle, e. g. a sufficiently dimensioned
wood plank.
The length of the plank should correspond to the width of the
installation niche!
• Specify the attachment points of the anti-tip-angles.
Specify the detailed dimensions according to the
section on "installation dimensions".
• Attach the anti-tip-angles completely. Be sure screws
hold tight.
Fastening with wood screws
4xl 5
Fastening with dowels and screws
Always wear safety glasses and other necessary pro-
tective devices or apparel when installing or working
with anchors.
Risk of injury!
Not recommended for use in light-weight masonry material
such as block or brick.
Not recommended for use in new concrete which has not
had time to cure.
Do not use core drills to drill holes for this anchor.
(
iiiJ
5x60
6x31
_06
22