Blade Fitting - Sima COBRA-40 Manual De Instrucciones

If the alignment is incorrect, adjust the engine's position until the pulley is aligned and belt tension is correct.
Finally, replace the belt guard (P, Fig.10) and fix it with its screws.
IMPORTANT
The transmission belts should be checked after 8 working hours and then should be adjusted.
It has been demonstrated that after many working hours the length of the standard-made profile driving belts
increases due to frictions, high temperatures, other tensions, etc....
When the driving of the machine is being made through toothed-made profile flat belts, it is not necessary to
adjust them. In that case, an excessive tension is not appropriate for the correct functioning of the machine.
K. BLADE FITTING
The cutting blade is one of the most important elements of the floor saw. A good blade is fundamental to get an
utmost performance of the machine. Change it ASAP if necessary.
Always use genuine SIMA blades and choose the most appropriate for the material being cut. SIMA S.A. offers you
a wide range for all your applications
10
ENGLISH