Inglesina APTICA Instrucciones De Uso página 27

CHASSIS
A Chassis structure
B Storage basket
C Feeding bottle holder
D Rear wheels
E Rear axle
F Front RH wheel assembly / Front LH wheel assembly
BASSINET
G Bassinet
H Hood lining
I Bassinet apron
STROLLER
J Stroller seat
K Handrail
L Hood
N Rain cover (if available)
P APTICA STAND UP (if available)
OPENING THE CHASSIS STRUCTURE
Holding the lever (A1) down, lift the chassis (A
both sides before use.
ASSEMBLING/REMOVING THE REAR WHEELS
Insert the rear axle (E) in both of the rear tubes (A2) of the chassis and push it
into its housing.
Ensure that the rear axle (E) is attached correctly, making sure that
both the pins (E1) are in their housings.
Insert the rear wheel (D) on the rear axle (E) and push it into its housing until it
clicks correctly into place. Proceed in the same way for the other wheel.
Should it be necessary, the rear wheels (D) and rear axle (E) can easily be removed.
Operate the lever (D1) and detach the rear wheel (D).
Holding down the pin (E1), remove the rear axle (E) from the chassis tube.
ASSEMBLING/REMOVING THE FRONT WHEEL ASSEMBLY
The front wheel assemblies are distinguished as RH and LH and can easily be
(F2) is also printed on both front chassis supports.
Insert the front wheel assembly (F) in the corresponding front chassis support
(F3), until it clicks correctly into place.
The hole (F4) on the wheel assembly and always kept on the outside helps to
identify correct RH and LH correspondence between wheels and chassis more easily.
INSTRUCTIONS
LIST OF COMPONENTS
CHASSIS
F1) printed by the attachment pin. The same reference
27