Conversion To A Different Type Of Gas; Gas Hob; Gas Oven; Commissioning - ALI C6FEV7G Serie Instrucciones Para Instalación, Uso Y Mantenimiento

ce must not be subjected to steam produced by drainage of
hot water.

10 CONVERSION TO A DIFFERENT TYPE OF GAS

Table T1 specifies, for each country:
• which gas can be used for the appliance
• the nozzles and settings for each gas that can be usedFor
nozzles, the number indicated in table T1 is also stamped on
the nozzle body.
To convert the appliance to the local gas type, follow the in-
structions given in atable T1 and carry out the steps below:
• Replace the main burner nozzle ( UM ).
• Adjust the main burner's air regulator to distance A.
• Replace the pilot burner nozzle ( UP ).
• Adjust the pilot burner air flow (if necessary).
• Replace the gas valve minimum nozzle ( Um ).
• Affix the adhesive tab indicating the new type of gas used.The
nozzles and adhesive tabs are supplied with the appliance.
10.1

GAS HOB

10.1.1 REPLACING THE MAIN BURNER NOZZLE
• Remove the control panel.
• Unscrew the locking nut of the tubing and the screw V that
secures the nozzle holder.
• Remove nozzle UM and replace it with the one indicated in
table T1.
• Retighten nozzle UM.
• Re-assemble all parts.For assembly, proceed in reverse or-
der.
10.1.2 REPLACING THE
SCREW
• Remove the control panel.
• Remove nozzle UM and replace it with the one indicated in
table T1.
• Retighten nozzle UM.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
10.1.3 REPLACING THE PILOT BURNER NOZZLE
• Remove the control panel.
• Undo connector R.
• Remove nozzle UP and replace it with the one indicated in
table T1.
• Retighten the connector R. Re-assemble all parts.
• For assembly, proceed in reverse order.
10.2

GAS OVEN

10.2.1 REPLACING THE MAIN BURNER NOZZLE AND
ADJUSTING THE PRIMARY AIR FLOW
• Remove the oven floor.
• Slacken screw V.
• Remove nozzle UM and replace it with the one indicated in
table T1.
• Retighten nozzle UM.
• Slacken fixing screw V and set the air regulator ferrule to di-
stance A as indicated in table T1.
• Retighten screw V fully.
10.2.2 REPLACING THE
SCREW
• Remove the control panel.
34
MINIMUM ADJUSTMENT
MINIMUM ADJUSTMENT
• Remove nozzle UM and replace it with the one indicated in
table T1.
• Retighten nozzle UM.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.

11 COMMISSIONING

See Chapter " INSTRUCTIONS FOR MAINTENANCE "

INSTRUCTIONS FOR USE

REMINDERS FOR THE USER

The manufacturer will not be liable for any damage or in-
jury resulting from failure to observe the following rules
• Read this manual carefully. It provides important information
for safe installation, use and maintenance of the appliance.
• Keep this manual in a safe place known to all users so that it
can be consulted throughout the working life of the appliance.
• Installation, conversion to a different type of gas and applian-
ce maintenance must be carried out by qualified technicians
authorized by the manufacturer, in compliance with current
safety standards and the instructions in this manual.
• For after-sales service, contact technical assistance centers
authorized by the manufacturer and demand the use of origi-
nal spare parts.
• Have the appliance serviced at least twice a year. The manu-
facturer recommends taking out a service contract.
• The appliance is designed for professional use and must be
operated by trained personnel.
• The appliance is to be used for cooking food as specified
in the reminders for use. Any other use must be considered
improper
• Do not allow the appliance to operate empty for prolonged
periods. Only pre-heat the oven just before use.
• Do not leave the appliance unattended while in operation.
• In the event of an appliance fault or malfunction, shut the
gas shut-off valve and/or switch the appliance off at the main
switch installed upline.
• Clean the appliance following the instructions given in Chap-
ter " INSTRUCTIONS FOR CLEANING".
• Do not store flammable materials in close proximity to the
appliance. FIRE HAZARD.
• Children should be supervised to ensure that they do not play
with the appliance.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Do not obstruct any air vents or drains present on the ap-
pliance.
• Do not tamper with appliance components.
• Do not pour water in the container when it is empty and hot,
as the burners may go out.
12 USING THE GAS HOB
REMINDERS FOR USE
• The appliance is designed for cooking foods contained in
pots and pans.
• The pilot burners have to be turned on manually.
• Check that the flame spreaders are correctly placed on the
burners.
• With the 3.5 kW burner, only use pots having a minimum dia-
meter of 150 mm and maximum of 300 mm.