Service And Adjustments - Craftsman 917.28856 Manual Del Operador

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center.
PROBLEM CORRECTION ......
Hard to start
2
Out of fuel
Engine not "CHOKED" properly.
3 Engine flooded,
4 Bad spark plug.
5 Dirty air filter.
6 Dirty fuel filter.
7 Water in fuel.
8 Loose or damaged wiring,
g Carburetor out of adjustment.
....... ,,,, , ...............
1. Fill fuel tank.
2 See "TO START ENGINE" in
Operation section.
3 Wait several minutes before
attempling to start,
4 Replace spark plug.
5 Clean/replace air filter.
6 Replace fuel filter.
7 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel fil'[er.
8 Check all wiring.
9 See "To Adjust Carburetor" in
Service and Adjustments section.
Contact a Sears or other qualified
service center.
1 Clean/replace air filter.
2 Replace spark plug,
3 Recharge or replace battery'.
4 Replace fuel filter.
5 Empty fuel tank and refiIt tank witl _
fresh, clean gasoline,
i
6 ! Check all wiring.
7 See "To Adjust Carburetor" in
SePaice and Adjustments section,
Contact a Sears or other qualified
service center.
Depress clutch/brake pedal.
Disengage attachment clutch.
Recharge or replace battery.
.EI.e. placefuse ...................
5 Clean battery terminals.
6 Check all wirir_j.
7 Check/replace ignition switch.
8 Check/replace solenoid or starter.
g Conta_ a Sears or other qualified
service center.
1 Recharge or replace battery.
2 Clean battery terminals.
3 Check nit wiring.
4 Check/reptace solenoid or starter,
10 Engine valves out of adjustment. 10
1 Dirty air filter.
2 Bad spark plug,
3 Weak or dead battery'.
4- Dirty f,ael filter.
5 Stale or dirty fuel.
6 Loose or damaged wiring,
7 Carburetor out of adiustment.
8 Engine valves out of adjustment. 8
Engine wilt not 1 Clutch!brake pedal not depressed 1
turn over
2 Attachment clutch is engaged. 2
3 Weak or dead battery. 3
4 . Blown fuse 4
will not start
5 Corroded battery terminals,
6 Loose or damaged wiring,
7 Faulty ignition switch.
8 Faulty solenoid or starter.
9 Faulty operator presence
switch(es),
1 Weak or dead battery,
2 Corroded battery terminals.
3 Loose or damaged wiring,
4 Faulty solenoid or starter,
28