Where To Place The Wind & Sun Sensor; Setting Of Several Motors To One Sensor - FAAC TM2 X SW Manual De Instrucciones

WHERE TO PLACE THE WIND & SUN SENSOR
ATTENTION!
The TM2 X SW sensor must be positioned to the side, as close as possible to its
awning, and not above or below the awning coverage area.
RIGHT

SETTING OF SEVERAL MOTORS TO ONE SENSOR

One single TM2 X SW sensor can be used to automate a group of motorised awnings.
For a correct function, the coupled awnings must be mounted and exposed to
sunlight and wind in the same way. Do not connect more then 5 motors to one
wind sensor.
RIGHT
TM2 X SW
WRONG
RIGHT
20
WRONG
WRONG
A4518_6H80_Rev.A