Deactivating Automatic Reopening; Setting The Sun Sensor - FAAC TM2 X SW Manual De Instrucciones

DEACTIVATING AUTOMATIC REOPENING

- only with TM2 ERY -
The automatic reopening function can be deactivated at any moment with the
following command sequence:
Tn: Already programmed remote control
+
A B
Tn

SETTING THE SUN SENSOR

The light level point can be set using the button
provided in the lower part of the TM2 X SW sensor,
identified by the sun symbol.
The light intensity can be set from a minimum of 2.5 kLux (dawn light) up to a maxi-
mum of 100 kLux (midday sunlight). To activate the automatic awning opening, the
light intensity must exceed the set level for 1 minute, while for automatic closing,
the light intensity must remain below the set level for at least 10 minutes. These
pause times are included to prevent the motor from moving continuously in the
event of passing clouds. Automatic opening and closing only work when the motor
is set to the automatic wind + light mode.
TM2 X SW
C
Tn
24
A
Tn (2 sec)
"SUN LIGHT"
SETTING
A4518_6H80_Rev.A