Important Warning; Connections To Be Made - Axxess BX-FD2 Instrucciones De Instalación

Applications
FORD
Edge 2007-2010
Escape 2008-2012
Expedition 2007-2014
F-150 (with CD player) 2009-2012
F-150 STX/FX2 base/XLT base
F-150 STX/XLT base
F-250/350/450/550
(with CD player) 2011-2012
F-250/350/450/550 XL/XLT
(with CD player) 2013-up
Focus 2008-2011
Fusion 2010-2012
Mustang 2009-2014
Taurus 2010-2012

IMPORTANT WARNING

This product includes instructions for an installation which must be carefully
followed. The instructions are worded in such a manner as to assume that the
Installer is capable of completing this type of electronic installation. If you are
unclear as to what you are instructed to do, or believe that you do not understand
the instructions so as to properly and safely complete the installation, then you
should consult a technician who does have this knowledge and understand-
ing. Failure to follow these instructions carefully, and to install the interface as
described, could cause harm to the vehicle or to the safety systems in the vehicle.
Interference with certain safety systems could cause harm to persons as well.
LINCOLN
MKX
MKZ
Navigator
MAzDA
2013 Tribute
2014 MERCuRy
Mariner
Milan
BX-FD2

Connections to be made

From the 16-pin harness with stripped leads to the
2007-2010
aftermarket radio:
2007-2009
• Connect the (2) Red wires to the accessory wire.
2007-2014
Note: If installing the AX-LCD (sold separately), there will be an accessory wire
2008-2011
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire.
2008-2011
Note: This wire must be connected for the interface to work properly.
2010-2011
• Connect the Orange/White wire to the illumination wire. (If the aftermarket
radio has no illumination wire, tape off and disregard this wire).
• Connect the Brown wire to the mute wire. (If the aftermarket radio has no mute
wire, tape off and disregard this wire).
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
For models without a Sony/THX amplifier:
• Tape off and disregard the Green, Green/Black, Purple, and Purple/Black
wires, they will not be used in this application.
For models with a Sony/THX amplifier:
• Connect the Green wire to the left rear positive speaker output.
2
Continued on the next page