shells sidewards so the guiding pins are released from the base, visual 30
4. Release the grilling shells, still tilted in a vertical movement out of the base. The inner surface of the
base as well as the outer surface of the grilling shells are now accessable for cleaning, visual 31
5. After cleaning, the grilling shells can be placed back in the base by following above steps vice versa. To
prevent damage, ensure that both guiding pins of the grilling shells are placed correctly in the designated
guiding slots in the base before sliding the shells in the base.
Cleaning and maintenance of the burner.
It's strongly recomended to inspect and clean the burner tube at least once a year, to keep your gas grill
performing safely and efficiently. To remove the burner(s) for extensive cleaning and inspection, please
carefully follow the instructions below in combination with the reference visuals shown on page 9.
Also follow these steps if an irregular flame pattern is visible.
1. Ensure that the gas supply is closed and the gas grill is cooled donw properly. Remove the 2 screws at the
center of the burner from the grilling shells, using a philips type screwdriver and carefully slide the burner
out from the grilling shell, visual 32
2. Below information should be taken in account during inspection and cleaning, visual 33:
- From repeated use of the grill, the burner openings can become dirty over time. Dirty and blocked ports
can restrict the gas flow which can cause dangerous situations.
- Inpect the inside of the burner tube with a flashlight to determine if any obstuction is visible that will
restrict the gas flow to the burner openings.
If any obstruction is visible on the inside or outside, clean the area with a steel britle brush or a steel wire.
Ensure that all blocked area's are clean before reinstalling the burner in the grilling shell.
For installing or replacing the burner, place the burner back in the grilling shell. Ensure that the tube is
placed properly over the gas orrifice and fasten the 2 screws.
Storage
When the appliance is not in use, the cylinder valve must be turned OFF, the appliance and the cylinder
together must be stored outdoors in a well ventilated area. However it is permissible to store the appliance
(but not the cylinder) indoors. Ensure the appliance is cleaned well, for sure the grates, before storing away.
When the gas cylinder is disconnected, replace the plug or cap on the valve outlet if available.
Extended storage
After extended storage it's recommended to clean and check the burner and gas supply,
instructions below.
Burner(s)
Brush the outside of the burners with a stiff brush, for example a 'hard' tooth brush, to remove stains and
dirt. Be careful not to damage the igniter spark points.
Gas supply & connection
1. Inspect the gas hose assembly for any deterioration and replace it if necessary.
2. Test the gas circuit for leaks and remedy any found, also see 'leak detection procedure' in the Gas con-
nections & regulator(s) section of this manual.
3.
Check if the seals of the gas hose assembly (between the appliance and the gas container) are in place
and in good condition, also before connecting a (new) gas container. These seals are located in the quick-
connectors and gas regulator, exact location also be found following the visuals on page 13, chapter
connections & regulator(s)". If it seems the seals need replacement, contact our Service & After-sales de-
partment for further advise and assistance.
7. Service & After-sales
Contact details
nomadiQ Europe Customer Service
+31 (0) 85 877 02 92
E-mail: questions@nomadiqbbq.com
Or fill out the online contact form: www.nomadiqbbq.com
following the
16
8. Warranty
This is nomadiQ's Warranty provided to you at no extra charge. It contains the information you will need to
have your product repaired in the unlikely event of a failure or defect.
Pursuant to applicable laws, the customer has several rights in case the product is defective. Those rights in-
clude supplementary performance or replacement, abatement of the purchasing price and compensation.
In the European Union, for example, this would be a two-year statutory warranty starting on the date of the
handover of the product. These and other statutory rights remain unaffected by this warranty provision.
In fact, this warranty grants additional rights to the owner that are independent from statutory warranty
provisions.
nomadiQ's Warranty
nomadiQ warrants, to the purchaser of the product (or in the case of a gift or promotional situation, the
person for whom it was purchased as a gift or promotional item), that the product is free from defects in
material and workmanship for the period(s) of time specified below when assembled and operated in ac-
cordance with the accompanying instruction manual.
Under normal, private single family home or apartment use and maintenance, nomadiQ agrees within
the framework of this warranty to repair or replace defective parts within the applicable time periods, li-
mitations, and exclusions listed below. TO THE EXTENT ALLOWABLE BY APPLICABLE LAW, THIS WARRANTY
IS EXTENDED ONLY TO THE ORIGINAL PURCHASER AND IS NOT TRANSFERABLE TO SUBSEQUENT OWNERS,
EXCEPT IN THE CASE OF GIFTS AND PROMOTIONAL ITEMS AS NOTED ABOVE.
Owner's responsibilities under this warranty
To ensure trouble-free warranty coverage, it is important that you register your nomadiQ product online
at www.nomadiQbbq.com, or such country-specific website to which owner may be redirected. Please also
retain your original sales receipt and/or invoice. Registering your product confirms your warranty coverage
and provides a direct link between you and nomadiQ in case we need to contact you. The above warranty
only applies if the owner takes reasonable care of the product by following all instructions as outlined in the
accompanying instruction manual, unless the owner can prove that the defect or failure is independent of
non-compliance with the above mentioned obligations. If you live in a coastal area, or have your product
located near a pool, maintenance includes regular washing and rinsing of the exterior surfaces.
Warranty handling/ Exclusion of warranty
If you believe that you have a part which is covered by this warranty, please contact nomadiQ's Service &
After sales service
nomadiQ will, upon investigation, repair or replace (at its option) a defective part that is covered by this
warranty. In the event that repair or replacement are not possible, nomadiQ may choose (at its option) to
replace the appliance in question with a new appliance. nomadiQ may ask you to return parts for inspection.
This WARRANTY lapses if there are damages, deteriorations, discolourations, and/or rust for which nomadiQ
is not responsible caused by:
• Abuse, misuse, alteration, modification, misapplication, vandalism, neglect, improper assembly or instal-
lation, and failure to properly perform normal and routine maintenance;
• Insects (such as spiders) and rodents (such as squirrels), including but not limited to damage to burner tubes
and/or gas hoses;
• Exposure to salt air and/or chlorine sources such as swimming pools and hot tubs/spas;
• Severe weather conditions such as hail, hurricanes, earthquakes, tsunamis or surges, tor
"Gas
does or severe storms.
The use and/or installation of parts on your product that are not genuine nomadiQ parts will void this war-
ranty, and any damages that result hereby are not covered by this warranty. Any
conversion of a appliance not authorised by nomadiQ and performed by a nomadiQ authorised service
technician will void this warranty.
PRODUCT WARRANTY PERIODS
Base & Grilling shells:
5 years, no rust through/burn through
(2 years paint excluding fading or discolouration)
Stainless steel burner tubes:
5 years, no rust through/burn through
Aluminium die-cast grates:
5 years, no rust through/burn through
WWW.NOMADIQBBQ.COM
17
na-