From The 24-Way Harness; From The 26-Way Harness - Axxess FRST-2 Instrucciones De Instalación

Connections to be made
• For Kenwood and select JVC radios: Connect the SWC wire (normally Blue/
Yellow) to the Brown wire of the ASWC. Isolate and tape the Brown/White wire, it
will not be used.
Some of the newer Kenwood radios will auto detect as a JVC. If this is the case, you
can use a 12k ohm resistor (included) in line between the Blue/Yellow and Brown
wire of the female 3.5mm jack during programming only. Or you can manually set
the radio type which is in the radio programming section of this manual.
• For Eclipse radios: Connect the Eclipse SWC wires (Normally Brown and Brown/
Black) to the Brown and Brown/White wires of the ASWC. Brown goes to Brown
and Brown/White goes to Brown/Black. Sometimes this is reversed, so reverse the
wires if needed.
• For Metra OE radios: Connect the SWC Key 1 wire (Gray) to the Brown wire
of the ASWC.
• For all other radios, plug in the male 3.5mm connector of the ASWC into the
back of the aftermarket radio, designated for an external SWC control interface.
Please refer to the aftermarket radios manual if you are in doubt where the 3.5mm
connector of the ASWC goes.

3. From the 24-way harness:

Connect the Black wire to the ground wire of the aftermarket radio.
•
Connect the Yellow wire to the constant wire of the aftermarket radio.
•
Connect the Violet wire to the right rear positive wire of the aftermarket radio.
•
• Connect the Violet/Black wire to the right rear negative wire of the aftermarket radio.
Connect the Green wire to the left rear positive wire of the aftermarket radio.
•
Connect the Green/Black wire to the left rear negative wire of the aftermarket radio.
•
• Connect the Blue wire to the antenna turn-on of the aftermarket radio.
• Connect the From 3.5 RCA to the AUX-in on the aftermarket radio
(if SYNC is not present).

4. From the 26-way harness:

• Connect the RSE/SYNC/SAT RCA to the AUX-in on the aftermarket radio
(if retaining SYNC).
FRST-2
5