Troubleshooting - Royal Sovereign ARP-7010 El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

Troubles
Air Conditioner does not operate
Air Conditioner runs but does not cool
Water Full indicator is lit up
Water is leaking from the unit
Machine automatically turns off
LED displays shows E0
LED display shows E1
LED display shows E2
LED display shows E3
- Check and reset the power plug. Wait 3 minutes and try to run the unit again.
- The batteries in the remote may need to be replaced. Replace the batteries and try to run the unit again.
- Make sure the plug is properly plugged into the outlet.
- The set temperature may be too close to room temperature. Lower the set temperature.
- The air outlet may be blocked. Check the air outlet and remove any items that may be found.
- Check the room for open doors or windows and close them.
- There may be another appliance in the room giving off heat. Check the room and turn off the appliance.
- The air filter may be dirty. Check the filter and clean if necessary.
- The air exhaust or intake may be blocked.
- The set temperature may be too high. Check the set temperature and reduce it if necessary.
- Unit needs to be drained. Follow draining instructions on page 11.
- Make sure unit is on a flat surface
- Drain the unit.
- Timer may have been set to shut off. Turn power back on.
- Room temperature sensor error
- Evaporator sensor error
- Water pump error
- Condenser sensor error
13
ARP-7010, ARP-7013, ARP-7013H
Possible Causes

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Arp-7013Arp-7013h

Tabla de contenido