Adjusting Volume; Lowering Volume Quickly; Setting The Time; Radio - Alpine CDA-9884 Manual De Operación

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.

Setting the Time

1
Press and hold F/SETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the Rotary encoder to select CLOCK ADJUST,
and then press /ENT.
3
Turn the Rotary encoder to set hour.
4
Press /ENT.
5
Repeat steps 3 and 4 above to set minute.
6
Press and hold F/SETUP for at least 2 seconds to
return to normal mode.
• Pressing /ESC returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is canceled.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
setting the "hour." Minutes will reset to 00. If the display shows over
"30" minutes when you do this, the time will advance one hour.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle's audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
/ENT for at least 2 seconds after
Remote control sensor

Radio

Rotary encoder
BAND
/ /
TUNE/A.ME
SOURCE/
/ESC
This unit cannot receive HD Radio™ signals (digital terrestrial radio).
In order to activate the digital radio functions described below, an
optional HD Radio Tuner module must be connected through the
Ai-NET bus.
HD Radio™ Technology Manufactured Under License From iBiquity
Digital Corporation. iBiquity Digital and the HD Radio and HD
Symbols are trademarks of iBiquity Digital Corporation. U.S. and
Foreign Patents.

Listening to Radio

1
Press SOURCE/ to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1) F2 (FM2) AM
3
Press TUNE/A.ME to select the tuning mode.
DX SEEK (Distance mode)
OFF (Manual mode) DX SEEK (Distance mode)
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or
continuously.
• If Digital Seek is set to ON, the SEEK UP/DOWN functions only stop
on digital station frequencies while receiving HD radio. Refer to
"Digital Seek ON/OFF Setting" (page 18).
/ENT
Preset buttons
(1 through 6)
F1 (FM1)
SEEK (Local mode)
will change the frequency
7
-EN