Vox; Squelch; Roger Beep (End Of Transmission Tone); Beep Tone - Midland G11V Manual De Uso

Vox

G11V enables hands free conversations through the VOX function: just
speak in the direction of the microphone and the communication will be
automatically activated.
The VOX sensitivity can be adjusted in 10 different levels (0,1,2,3...9)
trough the programming software:
0 means that the VOX is turned off, 1 is the lowest VOX sensitivity level
and 9 is the highest one.
By default, the VOX sensitivity of G11V is set on level 5.
To activate the VOX feature, keep pressed for about 4 sec. the Function
key1.

Squelch

The Squelch function suppresses noises on free channels and allows to
receive even weak signals.
G11V has 10 different Squelch levels settable by programming software:
0 means that the Squelch is turned off; from level 1 to level 9 you will
have different levels of noise reduction. The higher is the level, the louder
will be the Squelch.
By default, the Squelch level of G11V is set on level 5.
Make sure you do not set an excessively high squelch level because in this
case you may not be able to receive weaker signals. On the other hand an
excessively low Squelch value could enable the Squelch even when no si-
gnals are present.
Squelch must always be adjusted when no signals are present.
The Time Out timer is settable from 30 sec to 270 sec. only through the
programming software.
This feature is disabled by default.

Roger Beep (end of transmission tone)

When the PTT button is released, the radio will beep to confirm to other
users that you've finished your transmission and that they can begin to
speak.

Beep Tone

This function permit you to produce a beep tone every time you press a
button.
Midland G11V instruction guide | 7