Ecolab Chameleon PLUS Booster Advanced BW3 Guía De La Instalación página 3

6. Piping
The pipe system should be made of stainless steel pipes. The pipe joints
should be made in a way that makes separation possible in case of e.g.
repairs, movement or similar.
All thread according to ISO 228
The dimensions stated below are only intended as a guide.
Calculations on a new pipe installation should always be based on pressure
loss tables for pipes and fittings.
Pipe connections
Recommended pipe dimensions
Pipe dimensions unit
Pipe connections
Recommended pipe dimensions
Pipe dimensions unit
* To ensure an always sufficient water flow and a minimum pressure loss,
we recommend using a 2" pipe connection.
Always take into consideration, when planning and carrying out a new
installation, that the pipe connection of the unit is 5/4".
Note: A 5/4" - 2" closing valve should be mounted on the water supply im-
mediately before the Booster and dirt filter if any.
7. Assembly
Dimensions see fig.1 - fig.9
Professional:
Dimensions see fig. 1
It is recommended to mount the main station at an appropriate height (ap-
prox. 1 m above the floor) on a brick or concrete wall, according to mount-
ing instructions in fig. 2.
Mount the wall bracket.
For brick or concrete wall please use the screws and rawlplugs enclosed.
Now hang the main station on the wall bracket.
Secure the main station to the wall bracket using the enclosed screws.
Advanced:
It is recommended to mount the main station at an appropriate height (ap-
prox. 1 m above the floor from the bottom of the wall bracket) on a brick or
concrete wall, according to mounting instructions in fig. 4.
Mount the wall bracket.
Mount the main station with suitable securing. For brick or concrete wall
please use the screws and rawlplugs enclosed. To make mounting easier
we recommend marking the wall according to fig. 4. The main station must
be lifted until the auxiliary point on the right side is in line with the marking
on the wall. Now hang the main station on the wall bracket.
Fasten or tighten the main station to the wall bracket using the enclosed
screws.
BW3 BW4 BW7
5/4" RG 5/4" RG 2" RG*
5/4" RG 5/4" RG 5/4" RG
BF3 BF4 BF8
5/4" RG 5/4" RG 2" RG*
5/4" RG 5/4" RG 5/4" RG
3