Assembly; Unpackgenerator; Shipment Contents; Install Wheel Kit - Briggs & Stratton PRO1000G Manual Del Operador

Assembly
Your generator requires some assembly and is ready for use
after it has been properly serviced with the recommended oil
and fuel.
If you haveany problems with the assembly of your generator,
pleasecall the generator helpline at 1-808-743-4115. If calling
for assistance, pleasehavethe model, revision, and serial
number from the identification label available.See Generator
Controls and Featuresfor identification label location.
UnpackGenerator
1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.
Shipment Contents
The generatoris suppliedwith:
• Engine oil
• Operator's manual
• Batteryfloat charger
• Battery charge cables
• Wheel kit
• 120/240 Volt, 30 Amp locking plug
• 120 Volt, 30 Amp locking plug
Install Wheel Kit
NOTE:Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 3/8" and 13 mm wrench
• Socket wrench with a 3/8" and 13 mm socket
• Pliers
• Safety glasses
Install the wheel kit as follows:
1. Tip generator so that engine side is down.
2. Slide axle (A) through both mounting brackets.
3. Slide a wheel (B) over axle.
NOTE:Be sure to install wheel with raised hub inboard.
4. Place a washer (C) on axle and then place an e-ring (D)
in axle groove.
_i, CAUTION E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Alwaysweareyeprotection wheninstalling/removing e -rings.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
6. Repeat steps 3 through 5 to secure second wheel.