Sears Craftsman ZT 7000 Manual Del Dueño página 25

CHECK ENGINE OiL LEVEL -
BF{JGGS & STRATTON MODELS
Service lntervak Before each use, and every 8 hours.
1. Turn the engine off, and set the parking brake to
PARK.
2. Cban the area around the dip stick (C, Figure 29).
3. Remove the dip stick (C) and clean it with a paper
towel.
4,
5.
insert the dip stick back into the engine, Thread the
cap back onto the tube (D),
Remove the dip stick and read the oil level, The oil
level should be between the "FULE' and "ADD" marks
(D), if not, add oil according to the oil recommenda-
tions chart (Figure 28),
CHANGE ENGINE OiL °
BRJGGS & STRATTON MODELS
Service lntervak 50 hours or once per season.
Oil Capacity: 1=7/8 quarts (1.8L) without filter change.
NOTE; Change engine oil while the engine b warm, Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm,
1, Clean the area around the dip stick (C, Figure 29)
and oil drain tube (A),
2, Remove the oil drain plug (A) from the end of the oil
drain tube, Remove the dip stick (C), Allow ample
time for complete drainage,
3, Reinstall the oil drain plug (A) and route the hose
next to the engine,
4, Fill the crankcase with oil, See CHECK ENGINE OiL
LEVEL above,
CHANGE ENGINE OiL & FILTER
BF{JGGS & STRATTON MODELS
Service mntervaJ: 100 hours or once per season.
OH Capacity: 2 quarts (1.9L) with oil filter change.
NOTE: Change engine oil while the engine is warm, Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm,
1. Clean the area around the dip stick (C, Figure 29)
and oil drain (A).
2. Remove the oil drain plug (A) and and dip stick (C).
Allow ample time for complete drainage.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
Use oil classified API Service Class SF,
SG, SH, SJ or better with SAE Viscosity:
v
J I J
-20 0 20 32 40 60 80 1
-30 -18 -7 0 4 16 27 38
"F
°C
in temperatures above 40o F(4°6) will result hr higher than normal
oil consumption. Wben using a multi-viscosity oil, ebeek oil level
more frequently
**CAUTION: SAE 30 oil, if used below 400F (4°6), wifl result in hard
starting and possible engine bore damage due to inadequate
Bbrieation
Figure 28. Recommended Engine Oil -
Briggs & Stratton Modets
Figure 29. OH Change - Briggs & Stratton Modets
A. OH DrainTube
B. OH FHter
C. Dip Stick
D. Checking Oil Levet
6, Turn the filter clockwise until the rubber gasket meets
the filter base, Then turn 1/2 to 8/4 turn more,
7, Reinstall the oil drain plug (A),
8, Fill the crankcase with oil, See CHECK ENGINE OiL
LEVEL above,
9, Test run the engine to check for leaks, Stop the
engine for 1 minute, then recheck the oil level,
25