Attach Grass Bags - MTD OHD-190-180 Manual Del Operador

Figure 17
Figure 18
Figure 19
Attaching Grass Bags &
Grass Bag Cover
1. Place the support tube in position on the rear of unit
by sliding the support tube down through the holes in
the left side of the bracket assembly. Use the inside
hole on the bracket assembly regardless of what size
deck your tractor is equipped with. Refer to Figure 17.
2. Attach the grass bags by hooking them onto the grass
bag bracket using the slots in the grass bag and the
tabs on the grass bag bracket as shown in Figure 18.
3. Place the grass bag cover on top of the grass bags
and align the holes on the hinges of the grass bag
cover with the corresponding holes on the support
tube assembly. See Figure 19.
4. Insert the clevis pin through the hinge on the support
tube assembly and then through the grass bag cover.
See Figure 20.
5. Secure with belleville washer and hairpin clip with the
crown side of the washer going against the hairpin
clip. See inset images in Figure 20.
6. Repeat with the second set of hardware through the
second hinge of the grass bag and the tube assembly
from the opposite direction.
NOTE: Insert the clevis pins from the outside in as
shown in the inset images of Figure 20.
NOTE: It is very important to maintain this order
and direction while installing these hardware pieces.
After installation, make sure that the grass bag cover
pivots on the support tube and opens.
Figure 20
9
4
Attaching
Grass Bags
& Grass Bag
Cover
All Model Series
600 through 700
NOTE:
Insert the clevis pins
from the outside in as
shown in the inset
images of Figure 20.
NOTE:
It is very important to
maintain this order and
direction while installing
these hardware pieces.
After installation, make
sure that the grass bag
cover pivots on the sup-
port tube and opens.