Key Function; Operation - Caso IceMaster Pro Manual Del Usuario

15.1 Key function

A. Display size of the ice cubes (S = small or L = large) B. Operation display (Power)
C. Ice display (ice basket filled up)
E. On/Off button

15.2 Operation

Please note
► Please wait min 12 hours before you switch on the ice maker. You will find that the
cooling liquid settles out in this time.
 Open the cover of the ice maker and remove the ice basket.
 Fill water into the water reservoir and keep water level below the water level mark.
 Press the "Power" button to begin the ice making cycle.
 Select the ice cube size by pressing the "Select" button. If the room temperature is
lower than 15°C, it is recommended to select small ice cube in order to avoid ice
sticking together.
 Depending on selection of ice cube size and room temperature, the ice making cycle
lasts approx. 6 to 13 minutes.
 If water pump can't inject water, the ice maker will stop automatically. The "Add Water"
indicator will be on. Press the "Power" button and fill in water. Then press the "Power"
button again. Allow the ice maker at least 3 minutes to settle before restarting.
 The ice maker stops working when the ice basket is full. In this case the "Ice" indicator
will be on.
 Drain all the water, if unit isn't used. Always store the unit without water in the water
reservoir.
Attention
► Change water in the water reservoir every 24 hours to avoid pathogenic organisms.
Caso IceMaster Pro
D. Refill display for water
F. Button to chose size of ice cubes
31