Husqvarna 6021P El Manual Del Propietario página 16

Owner'smanual
Ocultar thumbs Ver también para 6021P:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

,_ WARNING: To avoid serious injury,
before performingany service and
adjustments:
1. Releasecontrol bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnectspark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
LAWN
MOWER
TO ADJUST CUTTING
HEIGHT
See "TO ADJUST CUTTING
HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator mowing position.
If the
deflector becomes damaged,
it should be
replaced.
TO ADJUST
HANDLE
The handle can be mounted in a high or
low position.
The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire
tie(s) securing cable(s) to lower handle.
2.
Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
6.
Reassemble
upper handle and all
parts removed from lower handle.
SQUEEZE
TO ADJUST
Lower
Mounting pin
Handle
Hairpin cotter
Mowing
r-'-q
_sition
_ J
\1
cotter
Ill--
Mountingll
u_
pin
LOW POSITION
Mowi ng
r-_-_
position
/
/
Handle
bracket
HIGH POSITION
16
,,
/_
&,,- _-Y '_
,,,
---_
ENGINE
ROTATE k_
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Husqvarna
or other qualified service cen-
ter for repair and adjustment.
CARBURETOR
Your carburetor
is not adjustable.
If your
engine does not operate properly due
to suspected carburetor
problems, take
your lawn mower to a Husqvarna
or other
qualified service center for repair and/or
adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Husqvarna
or other
qualified service center, which has proper
equipment
and experience
to make any
necessary adjustments.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

917.384520

Tabla de contenido