Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Before performing any type of maintenance/service, disengage all controls and stop the engine. Wait until all
moving parts have come to a complete stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting. Always wear safety glasses during operation or while performing any adjustments or
repairs.
This section addresses minor service issues. To locate the nearest Sears Service Center or to schedule service, simply contact Sears
at 1-800-4-MY-HOME®.
Problem
Engine fails to start
Engine runs erratically
Engine overheats
Loss of power
Excessive vibration
Snow thrower fails to self-
propel
Augers continue to rotate
Unit fails to discharge snow
TROUBLESHOOTING
Warning
Cause
1.
Fuel tank empty, or stale fuel.
2.
Blocked fuel line.
3.
Key not inserted all the way.
4.
Spark plug wire disconnected.
5.
Faulty spark plug.
6.
Engine not primed.
7.
Engine flooded from excessive priming.
1.
Engine running on choke.
2.
Fuel line blocked, or stale fuel.
3.
Water or dirt in fuel system.
4.
Carburetor out of adjustment.
1.
Carburetor out of adjustment.
1.
Spark plug wire loose.
2.
Vent in gas cap plugged.
1.
Loose parts or damaged auger.
1.
Auger control cable out of adjustment.
2.
Auger drive belt loose or damaged.
1.
Auger control cable out of adjustment.
1.
Chute assembly clogged.
2.
Foreign object lodged in auger.
3.
Auger control cable out of adjustment.
4.
Auger belt loose or damaged.
NEED MORE HELP?
Find this and all your other product manuals online.
Get answers from our team of home experts.
Get a personalized maintenance plan for your home.
Find information and tools to help with home projects.
1.
Fill tank with clean fresh gasoline.
2.
Clean fuel line.
3.
Insert key all the way.
4.
Connect wire to spark plug.
5.
Clean spark plug, readjust gap, or replace.
6.
Prime engine five to seven times.
7.
Wait at least ten minutes before starting.
1.
Move choke lever to OFF position.
2.
Clean fuel line and fill tank with fresh, clean gasoline.
3.
Drain fuel tank. Refill with fresh fuel.
4.
Contact a Sears Service Center.
1.
Contact a Sears Service Center.
1.
Firmly connect spark plug wire.
2.
Clear vent.
1.
Stop engine immediately and disconnect spark plug
wire. Check for possible damage. Tighten all bolts
and nuts. Repair as needed. If problem persists, take
snow thrower to a Sears Service Dealer.
1.
Adjust auger control cable as shown in Service and
Maintenance section.
2.
Replace auger drive belt.
1.
Adjust auger control cable as shown in Service and
Maintenance section.
1.
Stop engine and disconnect spark plug wire. Clean
chute and inside of auger housing with clean-out tool
or stick.
2.
Stop engine immediately and disconnect the spark
plug wire. Remove object from auger.
3.
Adjust auger control cable.
4.
Replace auger belt.
managemyhome.com – for free!
19
remedy
Publicidad
Tabla de contenido
Solución de problemas
