Before And After Fitting; Assembling; Activating; Charging - signia CROS Pure Charge&Go Nx Manual De Instrucciones

Before and after fitting
You have to prepare the CROS transmitter before you
can start fitting.

Assembling

A power cell is installed in every CROS transmitter on
X
delivery. There is no need to insert a battery.
Attach the suitable receiver unit
X
and a suitable ear piece to the
transmitter. The procedure is the
same as for any other of our RIC
hearing instruments.

Activating

Before first use or first fitting you have to activate the
CROS transmitter by putting them into the charger. Wait
until the first orange LED lights up.
Note:
●
CROS transmitter that are activated and not used
may discharge faster than transmitter that have not
been activated. Only activate the transmitter before
first use or first fitting.
4

Charging

The CROS transmitter are pre‑charged on delivery. They
should have sufficient power for a first fitting session.
We recommend to fully charge the transmitter before first
fitting and handover to the client. A full charging cycle
takes approximately 4 hours.
Follow the operating conditions in both the transmitter's
and the charger's user guide.

Connecting

Use Noahlink Wireless to fit the CROS transmitter
wirelessly.
5